MRA 4025066171927 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
1 Pair of retaining plates
8 Fillister head screw M5 x 20mm
8 Plastic washers 12x5x0.5mm
8 O-rings, 4.5x1.5mm
6 Distance sleeves 3mm
4 Elastic nuts M5
2 Spacer sleeves 6mm
1 Edge protection strip with clamping sleeves
Mounting the windscreen on the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the 4 original Allen screws from the headlight (P1).
3. Preassembling the retaining plates: Insert the M5X20mm fillister head screws [10673] with the plastic
washers [10635] through the retaining plates [11493]. Now, place the 3mm spacers [10872] against them
from behind and secure them with the small O-rings [10992] (P2).
Mount the retaining plates onto the motorcycle. Reuse the original fastening screws from the headlight mask
4.
(P3).
5. Give all the screws a few turns before tightening them. Now, align the retaining plates and tighten the screws
fully.
6. Preassembling the windscreen:
Mount the spacers with the M5X20mm fillister head screws and the plastic washers onto the MRA
windscreen. Place the spacers against the MRA windscreen from behind and secure them with the small O-
rings [10992].
The 6mm spacers [11038] are for the fastening screws at the top, the 3mm spacers [10872] are for the
fastening screws at the bottom (P4).
7. Mount the windscreen onto the motorcycle and align the windscreen; tighten all the screws.
8. Fit the protective edge strip onto the rear exposed part of the screen, as shown in Picture 5. Push the
clamping sleeves over the ends of the protective edge strip and lightly compress them, using a pair of pliers to
secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorized workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
YAMAHA MT 07 2021-
Article No..
--- 3, 4, 5mm Allen key
11493
10673
10635
10992
10872
10629
11038
---
2
Required tools