MRA 4025066171798 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA motorcycle windscreen
1 Pair of retaining plates
4 Socket-head screws M6 x 20 mm
4 Washers 12 x 6 x 1 mm
4 Caps M6
4 Plastic discs 12 x 5 x 0.5 mm
4 O-rings 4.5 x 1.5 mm
4 Spacer sleeves 3 mm
4 Oval-head screws M5 x 20 mm
4 Rubber nuts M5
1 Edge protector with clamp sleeves
Mounting the windscreen onto the motorcycle:
1. Place the motorcycle on an even surface.
2. Remove the four socket-head screws above the headlight (P1).
3. Ensure that the washers remain on the vehicle (as shown in image 1) as these may fall off during
disassembly.
4. Assemble the retaining plates [11487] of the MRA windscreen as shown in image 2 and mount these
onto the motorcycle (P3).
5. Tighten the fastening screws and fit the black cover caps [10581] over the screws (P4).
6. Now, take the MRA windscreen and insert the M5 x 20mm oval-head screws [10673] through the
windscreen holes along with the plastic washers [10559]. Place the 3 mm spacer sleeves [10872]
against these from behind and secure these with the small O-rings [10992] (P5).
7. Mount the windscreen onto the motorcycle and tighten all the screws.
8. Attach the edge protector section as shown in image 6. Cut off any excess.
9. Slide the clamp sleeves over the ends of the edge protector section and lightly press these together
using a set of universal pliers so that the edge protector is clamped.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
YAMAHA MT 09 2021-
Article No..
--- Allen keys 3 and 5 mm
11487
10662
10559
10581
10635
10992
10872
10673
10629
---
2
Required tools