Westfalia 313 082 300 113 Instructions De Montage page 47

Mercedes Benz Limousine and T-model type 202
Routing of Electrical Installation Kit
4
4
N28/2
a
Vehicles with carrier plate for additional
electrical equipment:
Lay retrofit control unit for trailer recognition
(N28/2) in the carrier plate (a). Route the
lacing of the trailer-hitch wiring harness (24) for
the left taillight, 13-pin trailer-hitch electrical
socket, earth connection and additional fuse
box in the carrier plate to the left and guide out
of the carrier plate near the left wheel arch.
Route the lacing of the trailer-hitch wiring
harness (24) for the right taillight and positive
connection in the carrier plate to the right and
guide out of the carrier plate near the wheel
arch.
All Vehicles
Lay retrofit control unit for trailer recognition (N28/2)
and trailer-hitch wiring harness (24) in the carrier plate
(a) and secure with Velcro strip.
N28/2 Retrofit control unit for trailer recognition
24
a
24
4
Trailer-hitch wiring harness
Carrier plate for additional electrical
equipment
Vehicles without carrier plate for additional
electrical equipment
Lay the retrofit control unit for trailer
recognition (N28/2) with the trailer-hitch wiring
harness (24) as per the description for the
carrier plate on the back of the removed
Styrofoam plate, mark the control unit and
wiring routing and cut out the Styrofoam plate
so that the control unit and wiring harness can
be laid cleanly under the plate.
Lay out the retrofit control unit for trailer recog-
nition (N28/2) and the trailer-hitch wiring
harness (24) on the luggage boot floor and
install the cut-out Styrofoam plate.
GB
47