Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.4GHz Troubleshooting Guide
Problem
Aircraft will not
"throttle up"but
all other controls
seem to function
LED on aircraft
remains lashing
and cannot be
controlled by
transmitter
Controls appear
to be reversed
after binding
to a different
transmitter
Aircraft does
not function
after connecting
light battery and
aircraft smells
burnt
www.modellmarkt24
www.modellmarkt24
Possible Cause
User did not lower throttle
trim and throttle stick
prior to initializing the
aircraft
Throttle channel is
reversed. Futaba tran-
smitters (equipped with
Spektrum modules) may
require you to reverse the
throttle channel
User did not wait at least
5 seconds after powering
the transmitter prior to
connecting the light
battery to the aircraft
User bound the aircraft to
a different transmitter
Transmitter was too
close to aircraft during the
initialization process
User did not initially set
up transmitter prior to
binding to the aircraft
User may have acciden-
tally plugged the light
battery in with the wrong
polarity
13
Solution
Lower throttle stick and
throttle trim to their lowest
settings
Reverse throttle channel
on speciic transmitter if
applicable
Unplug, then reconnect light
battery
Rebind aircraft to your desi-
red compatible transmitter
Move transmitter (powered
on) a few feet from the
aircraft prior to reconnecting
the light battery
See the "Binding" section of
this manual
Replace the receiver board
and ensure the RED polarity
marks are facing the same
direction when connecting
the light battery to the
receiver board
EN
Publicité
Table des Matières
