Range Testing - Spektrum AR9020 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
To Test
Conirm the failsafe settings are correct by turning off the transmitter. All channels
except for the throttle should hold the last command.
CAUTION: Make sure the aircraft is restrained on the ground. If failsafe is
not set, your aircraft might advance to mid or full throttle.
Preset Failsafe
If the signal is lost, all channels are driven to their failsafe position set during
binding. Preset Failsafe is ideal for sailplanes, as spoliers can be deployed during
loss of signal, preventing a lyaway.
How To Program
1. Insert the bind plug and power on the receiver.
2. When the receiver LEDs blink, indicating bind mode, remove bind plug before
binding the transmitter to the receiver.
3. LED lights will continue to blink.
4. Move transmitter' s control sticks and switches to the desired Preset Failsafe
positions, then turn it on in bind mode.
5. The system should connect in less than 15 seconds.
NOTICE: Failsafe features vary according to receiver, so if using a receiver other
than the AR9020, consult your receiver' s instructions for the failsafes that apply.
Before light, ALWAYS conirm your binding is good and failsafe is set. To do
this, make sure the system is connected turn your transmitter off. Conirm that
low-throttle is active.
CAUTION: Make sure the aircraft is restrained on the ground. If failsafe is
not set, your aircraft might advance to mid or full throttle.

Range Testing

Before each lying session and especially with a new model, perform a range check.
All Spektrum aircraft transmitters incorporate a range testing system which, when
activated, reduces the output power, allowing a range check.
1. With the model restrained on the ground, stand 30 paces (approx. 90 feet/28
meters) away from the model.
2. Face the model with the transmitter in your normal lying position and place your
transmitter into range check mode. This causes reduced power output from the
transmitter.
3. You should have total control of the model in range test mode at 30 paces
(90 feet/28 meters).
www.modellmarkt24
www.modellmarkt24
30 paces (90 feet/28 meters)
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ar12020

Table des Matières