Publicité
Les langues disponibles
Les langues disponibles
COMPUTER FUNCTIONS
• Scan:
Automatic display change of all function values
• Time:
Display of the training time (0:00 - 99:59 min.)
• Speed:
Speed display (0.0 - 99.9 km/h)
• Distance:
Distance (0.0 - 99.9 km)
• Calories:
Approx. calorie consumption (0.0 - 9999 kcal)
• Odo:
Total distance (0.0 - 9999 km)
• Pulse:
Pulse rate (40 - 240 beats/minute)
For a correct reading, please make sure that you are correctly
the two sensors correctly with your palms. It may take up to
2 minutes before the pulse rate is measured correctly.
BATTERIES
The computer requires 2 AAA 1.5V batteries.
BUTTONS AND OPERATION
The computer will switch on when you press the button or start exercising. After about 4 minutes of no activity,
the computer will automatically switch off.
RESET:
All values will be reset when you press and hold this button for approx. 3 seconds or when the batteries
are removed.
MODE:
With this key you can select the desired function to be displayed (or preset). If „Scan" is selected, all
function values are displayed one after the other in an automatic cycle. A small arrow is displayed additionally,
which always points to the currently active function.
SET:
With this button you can set target values for time, distance or calories. After setting, these values will then
count down to 0.
Notes:
• If the computer display does not show any values, please carefully check all cable connections for proper contact!
• The calorie consumption values registered and displayed with this computer merely serve as indicative values for a person
of medium stature with medium resistance setting, and can deviate considerably from the actual medically precise calorie
consumption.
• The pulse values registered and displayed with this computer are merely indicative in nature and can deviate considerably
from the actual pulse.
• This computer has been tested according to the appropriate applicable EMC standards. Nevertheless, it is possible that the
display may be disturbed, especially by electrostatic discharges. This may result in an unwanted reset or a faulty display. In
such a case, you only need to restart the computer (switch it off and on again).
19
COMPUTER INSTRUCTIONS
Publicité
Chapitres
