Snap-On EEWH312A Instructions D'utilisation page 6

IMPORTANT !! SAVE THESE INSTRUCTIONS — DO NOT DISCARD !!
Tires and rims that are not the same diameter are mismatched.
NEVER attempt to mount or infl ate any tire and rim that are mismatched.
·
ALWAYS check to see that tire and rim diameters are the same.
·
A mismatched tire and rim could explode causing death or serious personal injury.
Over-pressurized tires can explode causing fl ying debris.
Read and understand Operator's Manual before operating.
·
Keep bystanders away from work area.
·
ALWAYS wear Safety Goggles.
·
ALWAYS check to see that tire and rim diameters are the same.
·
NEVER attempt to mount or infl ate any tire and rim with diff erent diameters.
·
Inspect tires. NEVER infl ate tires that are damaged, rotten or worn.
·
NEVER infl ate 'Split Rim Wheels' on this tire changer or remove them and use only
·
an approved safety infl ation cage designed for this purpose.
Lock turntable clamp on inside of rim before attempting to infl ate tire.
·
Use approved tire bead lubricant before removing or installing tire on rim.
·
ALWAYS position the "Safety Restraint Arm" over the wheel to hold it to the
·
turntable while infl ating if so equipped.
If a tire explodes on this tire changer, STOP using it until the "Safety Restraint Arm"
·
has been replaced, which must be done even if no damage is seen.
NEVER place head or body over a tire during infl ation process.
·
Use short bursts of air to seat tire beads. Check tire air pressure
·
frequently. NEVER exceed tire manufacturer's pressure limits.
NEVER attempt to bypass or alter the built-in air pressure limiter. Only infl ate tire
·
with air hose supplied with tire changer. NEVER use shop infl ation hose to infl ate a tire.
Tire Changer must be anchored to concrete fl oor if equipped with a "Safety
·
Restraint Arm".
Exploding tires can cause serious injury.
Snap-On EEWH312A
EN - 6