Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BEFORE INSTALLATION
Before installation read the operation manual thoroughly This
way you can use all the benefits of the device and prevent damage.
•
Only an electrician or a person with equal qualifications may
install the device.
•
Installation and maintenance of the device is only allowed when it
is not under voltage.
•
For unique problems that are not covered in the installation
manual, contact your vendor to ensure safety.
•
It is not permitted to alter or rebuild the control device without
authorisation.
•
The manufacturer has the right to make improvements to the
device. The latest version of the operation manual can be found
on the manufacturer's webpage (www.huum.eu).
•
Make sure that the building's cables from the main switchboard
to the sauna's desired location have sufficient a cross section.
In case of an older building, pay attention to the condition of the
connecting boxes and if possible, install a new cable from the
switchboard to the sauna. Install separate protection for the heater.
•
It is recommended to connect the unit to the mains without an
earth-leakage circuit breaker.
•
This product is intended to operate with equipment that meets
the requirements of EN 60335-2-53: 2011.
Symbols used in the installation manual
In the guide, the following details of the sauna are marked with
numbers:
UKU control panel
1
Main controller
2
Door sensor
3
Temperature sensor
4
Heater (not included)
5
Vaporiser (not included)
6
Light (not included)
7
4
Publicité
Table des Matières
