Switching The Scales Off; Saving A Measurement - SilverCrest SNAW 1000 D2 Mode D'emploi

NOTE
► As energy and nutritional values fluctuate naturally, these values only serve
as guide values.
► If you make a mistake when entering the code, simply re-enter the code.
Switching the scales off
Press the ON/OFF button 9 to switch off the scales. The scales switch off.
or
Wait about 60 seconds after the last action. The scales switch themselves off
automatically.

Saving a measurement

You can save all displayed values for a food. The scales will automatically add
the values to each saved measurement. For instance, you can enter every item of
food you eat over the course of a day and view the data at the end of the day.
The saved values are retained, even after you switch off the scales or change the
battery.
1) Weigh some food as described in the previous section and enter the appro-
priate food code so that the nutritional and energy values are displayed.
2) Press the M+ button 0 to save the measurement.
ΣM XX appears on the measured value memory display r. "XX" is displayed
as a two-digit number, e.g. ΣM 01 and shows the memory location.
NOTE
► You can only save measurements for which you have also entered a
code.
► If make a mistake when entering the code, you can only change the
code before saving by entering it again. It is not possible to change the
code subsequently.
3) Now take the food off the scale and place the next item on the weighing
platform 1.
4) Proceed in the same way to save additional nutritional values. After each
further value stored, the number of the measured value memory display r
is increased by one. The number from the last weighing is displayed.
■ 10 │ GB │ IE SNAW 1000 D2