Publicité
Les langues disponibles
Les langues disponibles
heat up automatically when the DMX signal is disconnected. Automatic heating function can be
set on or off.
If the machine is connected to a DMX signal, the heating can only be started by the DMX control-
ler.
SET CHANNEL MODE
Please refer to the MENU chapter to set to the desired number of channels.
SET DMX ADDRESS
Please set the DMX address according to the selected channel mode:
If the machine is set to 2 channels, please set the DMX address to 1, 3, 5, 7, etc.
If the machine is set to 3 channels, please set the DMX address to 1, 4, 7, 10, etc.
RFID TIME CARD
In order to avoid misuse, failures and accidents caused by unqualified persons, the machine can
only be used with a special RFID time card.
Each swipe of the card recharges the operation time for 12 minutes. You can only swipe the card
twice for 24 minutes operation max.. The card can only be swiped again when the remaining time
is less than 20 minutes.
START TO SPARK
Turn on your DMX controller
Turn on the heating function
• The heating function of the second DMX channel has the value 240-255. It takes about 5 minutes
to preheat after power on.
• When the heating is turned on, the HEAT indicator light on the machine will turn to red and the
READY indicator flashes green.
• When heating is completed, the READY indicator lights steadily green and the machine enters
into sparking status.
ADJUST SPARKING HEIGHT
Adjust the sparking height via channel 1. The DMX value of height adjustment is 11-255.
The maxiumum height of indoor and outdoor granule is different. The maximum height of indoor
granule is 3.5m while outdoor granule is 5 meters. The height and direction are also affected by
wind conditions.
ADJUST SPARKING DENSITY
The machine has an independent sparking density adjustment. You can control the density dur-
ing sparking which allows more special effects during the show.
The third channel is dedicated to the density adjustment. The density can be adjusted between
30 and 100%.The default sparking density is 100%. The DMX values are 0-255. 0 means 100%
density. The higher the DMX value, the lower the density.
USE OF THE REMOTE CONTROL
Turn on power and don't connect a DMX signal.
On the first screen hold ▲ on the control panel of the machine
for 2 seconds until the display shows "Control Pair Remoter
315M".
Press "B" on the remote control until the display shows "Code
Success".
One remote control can control up to 4 machines.
Please note that the DMX signal must be disconnected during pairing and use of the remote control, otherwise the remote will not work.
Sparking stops automatically after 30 seconds and clearing material stops after 5 seconds.
www.afx-light.com
A
ON
B
OFF/CODE
C
D
DIGITAL REMOTE
CONTROLLER
HEIGHT
CLEAR MATERIAL
7
EN
Publicité
