Altrad Belle RANGER 450 Manuel De L'opérateur page 15

• Take the Floor Saw to where it is required.
NEVER
• Having carried out the checks listed in the 'pre start' section, you may start the engine.
• Set the throttle to maximum, use the control lever to gently lower the blade into the cut and use the depth marker to
achieve the required depth of cut.
The saw will then require gentle forward movement to achieve the cut.
The speed of travel will be determined by the condition of the surface being cut.
DO NOT stand in line with the blade and the stream of hot particles whilst sawing.
excessive wear of the blade.
DO NOT try to force the saw forwards as this will cause damage to the blade.
DO NOT
then turn the engine ON/OFF switch to 'O'.
• The water spray system is designed to supply a steady stream of water to enable dust suppression whilst the machine is cutting.
This prevents clogging of the engine with dust and helps to prevent pollution of the atmosphere.
CAUTION
spanners provided.
rotation of the tool.
plate.
Operating Instructions
ALWAYS
Blade Fitment
15
GB
GB