Brouwland Vinoferm 015.080.12 Manuel D'utilisation page 5

Vinoferm Fruit Press wooden basket 12 l + 18 l
EN ®
015.080.12 + 015.080.18
Thank you for purchasing the Vinoferm
PARTS LIST:
Part No. Description
1 Handle
2 Trunnion
3 Nylon washer
4 Metal pressing plate
5 Wooden pressing plate
6 Wooden blocks
7 Wooden plate
8 Threaded rod
9 Juice bag
10 Metal ring
11 Screw
12 Cage slat
13 Base
Remark:
Model Part 11 Part 12
12 l 53 pcs 25 pcs
18 l 53 pcs 25 pcs
Additional parts that may be needed but are not included: screws to mount feet
of base to solid base.
Distributed by Brouwland
Korspelsesteenweg 86
3581 Beverlo, Belgium
www.brouwland.com
Fruit press.
®
QTY
1
1
1
1
1
4
2
1
1
2
See remark
See remark
1
Vinoferm Fruit Press wooden basket 12 l + 18 l
®
015.080.12 + 015.080.18
Instruction manual
USAGE:
The Vinoferm Fruit Press needs to be assembled. You can find the assembly
• ®
instructions further on.
Clean the Vinoferm Fruit Press before and after each use with Chemipro
• ®
Wash and Chemipro San. Then dry thoroughly.
®
If left unused for prolonged periods, coat all metal components with a thin
•
film of Vaseline or food-safe oil and store in a clean, dry environment. Check
the press's condition before using again and if mold is apparent, wash
thoroughly, rinse, dry and apply a film of fresh food-safe oil to its metal
components.
Before use, all components must be scrupulously clean and all traces of old
•
oil removed to avoid the possibility of contamination of the produce.
To maximise the yield from your fruit, it is best to grind or crush the fruit prior
•
to pressing. You can run the fruit through your fruit crusher, shredder or food
mill to reduce the size.
Ensure that the legs of the Vinoferm
•
to a flat surface prior to pressing. This will prevent the unit from sliding or
tipping over during operation.
Keep hands clear while the press is turning.
•
Do not alter the handle by making it longer.
•
There is a 2-year warranty on this Vinoferm
•
ASSEMBLY AND OPERATION:
1. Wooden barrel assembly--- Assemble metal ring (10) and cage slat (12),
make sure all cage slats (12) with bevel edge are in one direction, the
opposite end with smooth edge in line in the opposite side.
2. Wooden pressing plate (5) and metal pressing plate (4) assembly with
screws (11).
3. Threaded rod assembly (8), then mount to the base (13). NOTE: The
threaded rod with the 2 small pieces, should be assembled first.
Fruit Press are attached and screwed
®
Fruit press.
®
bevel edge
smooth edge
®