Technical Data; Starting Up - Grizzly Tools BHS 2670 E2 Traduction De La Notice D'utilisation Originale

GB
damage the appliance and cause a seri-
ous risk for operators. The equipment is
intended for use in the field of DIY. It is not
designed for commercial use.
The appliance is intended for use by
grown-ups. Young persons above the age
of 16 may use the appliance under super-
vision only. Operation in the rain or in wet
environments is prohibited.
The operator or user is liable for acci-
dents, injury to humans or damage to their
property.
The manufacturer shall not be liable for
damages caused by non-intended or inap-
propriate operation.

Technical data

Petrol hedge trimmer ........BHS 2670 E2
Engine .. single-cylinder two-stroke engine
Displacement ..................................26 cm
Engine power............................... 0.75 KW
Maximum engine speed ...........10000 rpm
Recommended idling speed .......3000 rpm
Cuts per minute ............... 1700 stroke/min
Spark plug: .........................Torch L8 RTC
alternative ................. Champion RC j6Y
Cutting length ...............................550 mm
Tooth gap ........................................27 mm
Tank volume, max. ........................... 0.46 l
Fuel mixture ........................................40:1
Weight .............................................5,5 kg
Sound power level (L
measured .... 106,9 dB(A); K
guaranteed .............................109 dB(A)
Sound pressure level (L
...............................95,8 dB(A); K
Vibration (a )
h
Front handle ..... 7,152 m/s
Rear handle...... 3,378 m/s
The specified vibration emission rating
has been benchmarked by a standardised
test method and can be used to compare
different electric tools.
80
)
WA
= 2,32 dB
WA
)
pA
= 3 dB
pA
; K= 1.5 m/s
2
2 ; K= 1.5 m/s
The specified vibration emission rating
can also be used to preliminarily assess
the operator's exposure.
Warning:
Depending on how the electric tool
is used, the actual vibration emis-
sion rating during operation may
differ from the specified one.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched
on but running without any load).
3
Noise and vibration ratings have been
determined pursuant to the standards and
regulations specified in the declaration of
conformity.

Starting up

After turning off the appliance,
the blades will keep moving for
a short while. Allow the blades
to come to a halt, do not touch
the moving blades and do not
slow them down. Risk of injury!
Read the safety instructions be-
fore starting the appliance. Do not
operate the appliance without the
hand guard. To operate the appli-
2
2 ance, wear suitable clothing, work
gloves as well as head, eye and
ear protection. Prior to every use,
check that the appliance is opera-
tive. Only use OEM parts.