Filling Up; Tests Before Starting The Appliance; Starting The Motor - Grizzly Tools BHS 2670 E2 Traduction De La Notice D'utilisation Originale

Before operating the device, you must fill
it with fuel.

Filling up

Ensure proper ventilation when
handling fuel. Do not smoke
when filling up and keep away
all heat sources. Do not fill up
when the motor is running or
still hot. Carefully remove the
filler cap to allow any excessive
pressure to relieve slowly. Do
not start the appliance near the
place of filling up. Use suitable
and admissible vessels to keep
the fuel in. Non-compliance
causes a risk of fire or explo-
sion.
Use the fuel mixture recommended
in the manual only. Verify that it is
no older than 3 months. Non-com-
pliance may damage the motor
and your warranty will be voided..
Prevent petrol from coming into
contact with your skin and do
not inhale petrol fumes. Health
risk!
The appliance runs on a 40:1
mixture of unleaded petrol
and two-stroke engine oil
(API TC quality).
Table of fuel mixtures:
Petrol Grizzly Tools two-stroke oil
3,00 litres
4,00 litres
5,00 litres
40 parts of petrol + 1 part
Mixing
75 ml
100 ml
125 ml
of oil
• Do not use undiluted fuel. Only use
two-stroke oil (no four-stroke oil or oil
for water-cooled engines). Non-com-
pliance may damage the motor and
your warranty will be voided.
1. Prepare the petrol/oil mixture in a
clean canister intended for use with
petrol.
2. First fill in half of the petrol, then all
of the oil, then shake the canister. Fill
in the rest of the petrol and shake the
canister again.
3. Remove the filler cap and fill the fuel
mixture into the petrol tank. Wipe
spilled fuel from around the filler open-
ing and replace the filler cap.
Tests before starting the
appliance
• Verify that the spark plug connector
is attached properly. A lose connector
may produce sparks that might ignite
any fuel-air mixture escaping.
• Verify that all switches move freely
and that the safety devices are opera-
tive.
• Verify that the blade is mounted prop-
erly and that the handles are clean.
• Verify that there is enough fuel in the
tank and fill up as necessary.

Starting the motor

1. Place the appliance on a solid and
even surface. Check that the blade
is not touching any objects or the
ground.
2. To start the ignition, move the On/Off
switch (17) to I.
3. For a cold start, set the choke lever (7)
to the „START"
For a warm start, leave the choke le-
ver (7) in the „RUN"
GB
position.
position.
81