Table des Matières
Publicité
Do not overfill the portafilter. The coffee ground should not make contact
6
with the brewing head when placed to ensure a proper seal.
10. Remove any coffee ground from the edge of the portafilter p.
11. Insert and rotate the portafilter
into the brewing head 6. Make sure the handle is aligned with
p
the CLOSE marking.
Make sure the portafilter is firmly installed. If the portafilter does not turn
6
easily in place, remove the portafilter and reduce the amount of coffee
ground.
12. Place one or two cups from the cup tray
8
When the cup extraction buttons
light up you can start the brewing process.
2 3
Do not leave the appliance unattended when in use.
6
13. Press the corresponding cup extraction button
14. Check during the process if the manometer
If you need to stop the process before it is finished, press the corresponding cup extraction button
4
again. The maximum brewing time is 60 seconds.
Be careful when emptying the portafilter directly after use. The appliance and
6
the coffee cakes are still very hot.
If you need to program the extraction volume press and hold one of two cup extraction buttons and
4
release the button when the desired amount is reached.
15. Remove the portafilter
from the brewing head 6.
p
16. Empty the cup filter
in a knock box or a bin.
f g j k
When you want to make another espresso, repeat the steps in this chapter. When you are finished we
recommend cleaning the appliance (Chapter Daily maintenance).
S T E A M I N G M I L K
V
During or directly after use, only touch the rubber handle of the steam and
6
hot water wand. The steaming wand gets hot.
You can use steamed milk for example in a cappuccino or a caffè latte.
4
You can also use the steaming function for heating chocolate milk or other beverages.
4
1.
Press the steaming function button
to activate the steaming function.
1
The appliance heats up the steaming function. The steaming function button
steaming function is ready, the steaming function button
Fill the milk jug
2.
with milk (max. half a jug).
y
If the steaming wand is used for dispensing hot water, the steaming wand dispenses water residue
4
before the steaming function activates. For good steamed milk, first dispense the residue before
putting the steaming wand into the milk.
Check if the steaming function button
3.
1
4.
Lower the nozzle of the steaming wand
e
38
underneath the spouts of the portafilter.
to start the process.
2 3
goes from 0 to the optimal range (8 – 12 bar).
5
blinks. When the
1
constantly light up white.
1
constantly lights up white.
a few millimeters into the milk.
Rotate the steaming knob
counterclockwise to switch on the steaming wand e.
5.
q
6.
Wait until the milk is steamed as desired.
When you cannot touch the side of the milk jug for longer than 3 seconds, the temperature is
4
optimal (approximately 65 °C).
7.
Rotate the steaming knob
clockwise to switch off the steaming wand e.
q
When not switched off, the steaming function automatically switches off after 2 minutes.
4
The steaming wand is hot after use!
6
8.
Take the steaming wand
out of the milk.
e
Position the steaming wand
above the water tray t.
9.
e
10. Clean the nozzle of the steaming wand
e
11. Rotate the steaming knob
to remove all milk from the steaming wand e.
q
12. Press one of the cup extraction buttons
2 3
The cup extraction buttons
start flashing. When the cup extraction buttons
2 3
light up white, the system is ready for making coffee.
13. Pour the frothed milk directly into an espresso.
14. Clean the milk jug
with water or in a dishwasher after use.
y
U S I N G T H E H OT WAT E R F U N C T I O N
V
During or directly after use, only touch the rubber handle of the steam and
6
hot water wand. The steaming wand gets hot.
Lower the steaming wand
1.
into a cup.
e
Do not point the tip of the steaming wand directly on the bottom of the cup.
6
Rotate the steaming knob
anticlockwise to dispense hot water from the steaming wand e.
2.
q
Rotate the steaming knob
3.
clockwise to stop the hot water function .
q
When not switched off, the hot water function automatically switches off after 2 minutes.
4
You can also use the hot water function to preheat the cups.
4
D A I LY M A I N T E N A N C E
V
We recommend doing the following maintenance daily (before first coffee):
1.
Place a container underneath the brewing head 6.
2.
Press one of the cup extraction buttons
2 3
3.
Dry the brewing head
with a cloth.
6
4.
Rinse the portafilter
and the used filters
p
5.
Dry the portafilter
and the used filters
p
Check if the red floater of the drip tray
6.
is visible through the grid.
t
If so, clean the drip tray
7.
(chapter Weekly maintenance).
t
W E E K LY M A I N T E N A N C E
V
We recommend doing the following maintenance weekly:
Empty the drip tray t.
1.
Clean the drip tray
2.
with water and a mild detergent.
t
with a damp cloth.
to cool down the steaming function.
constantly
2 3
to rinse the brewing head 6.
with tap water.
f g h j k
with a cloth.
f g h j k
39
Publicité
Table des Matières
