Abus TVIP42510 Manuel Utilisateur page 110

Min. size:
Detection area:
Delete:
Region:
Threshold:
Sensitivity:
Schedule
To save a schedule, click on "Activate schedule". Specify here on which days of the week and at which times
the alarm output should be active.
The period selection is made by holding down the left mouse button. By clicking on an already marked period,
the details can also be set via keypad or deleted again.
To copy the time selection to other weekdays, move the mouse pointer behind the bar of the weekday already
set and use the "Copy to ..." function.
Apply the settings made by clicking "Save".
Linkage method
Here you can set the action to be performed when an event occurs.
Normal Linkage
Send email:
Notify the surveillance centre:
Uploading to FTP/Memory card/NAS:
Trigger recording
Enable this in order to record motion detections onto an SD card.
This function determines the minimum size of the object to be detected. This is done
by drawing a rectangle in the preview video. The rectangle can be drawn anywhere in
the preview video.
The area to be monitored can be drawn in the video image (quadrilateral area).
Operation: Press button -> set corner points using left mouse button (max. 4) -> press
right mouse button to finish drawing
delete the area.
Number of available areas: 4
The higher the value (0-10 seconds), the longer an object has to stay in the area to
be monitored in order to trigger an event.
higher sensitivity allows smaller objects to be detected.
You receive an email as notification; check the checkbox to activate this.
If an event is triggered, the ABUS CMS software can be
informed. You may then get a picture pop-up, for example.
Check this check box to upload single frames to an FTP server,
the SD card or a connected NAS drive during an event.
110