Nat - Abus TVIP42510 Manuel Utilisateur

8.3.4 NAT

Enable UPnP:
Name:
Port Mapping Mode
Select here whether you wish to conduct port mapping automatically or manually.
You can choose between "Auto" or "Manual".
Protocol Name:
HTTP
The default port for HTTP transmission is 80. As an alternative, this port can be assigned a value in the range
1025 ~ 65535. If several IP cameras are located on the same subnetwork, each camera should have its own
unique HTTP port.
RTSP
The default port for RTSP transmission is 554. As an alternative, this port can be assigned a value in the
range 1025 ~ 65535. If several IP cameras are located on the same subnetwork, each camera should have its
own unique RTSP port.
Server port (control port)
The standard port for SDK transmission is 8000. Communication port for internal data. As an alternative, this
port can be assigned a value in the range 1025 ~ 65535. If several IP cameras are located in the same
subnetwork, each camera should have its own unique server port.
External Port
You can only change ports manually here if the "Port Mapping Mode" was set to manual.
Status
Displays whether the external port entered is valid or not valid.
Activation or deactivation of the UPnP interface. Upon activation, the camera, for
example, will appear in the Windows network environment.
Definition of the name for the UPnP interface (this name will be assigned to the
camera, for example, in the Windows network environment.)
93