Changing Tires - Cartrend 50275 Notice D'instructions Originale

Warning! Follow the information in the vehicle
manufacturer's handbook concerning the use of this
product. Do not exceed the recommended information
in any case. The wheel nuts must be tightened pursuant
to the torque information listed in the owner's manual
of the vehicle. Excessively tight or loose wheel nuts
may cause tire failure.
• Put the vehicle in gear or set the automatic transmission to "P". Set
the parking brake to block the wheels.
• Ensure that no persons are located inside the vehicle.
• Lift the vehicle with the original accessory and tool of the vehicle
manufacturer. Ensure strict compliance with the manufacturer's
manual.
• Secure the vehicle against rolling away and use safety supports.
• Select a suitable socket. While inserting, ensure that the socket is
firmly and securely located in the tool mount (6).
• Connect the power plug (2) to a suitable power outlet.
• Firmly place the tool on the tire's mounting material.
• Push the rotational direction switch (5) to the clockwise position
to tighten the mounting material (clockwise). Before using the tool,
ensure that the rotational direction is correct.
Attention! For safety reasons, the torque is limited to 100
nm for clockwise direction. Please use a torque wrench to
tighten the wheel bolts to approximately 120 nm. Please
note that the wheel bolts must be retightened after a driving
distance of approximately 50 km. Inspect that the wheel bolts
are tight.
• Set the rotational direction switch (5) to the counterclockwise position
to remove the mounting material (counterclockwise perception). Before
using the tool, ensure that the rotational direction is correct.
• Removing wheel nuts/screws may require several impacts.
• Release the on/off switch (3) to stop the tool.
• After completing the work, disconnect the power plug (2) from the
power outlet.
50275_Schlagschrauber_Expert_BA_171026.indd 31

6.3 Changing tires

31
26.10.17 14:01