Cartrend 50275 Notice D'instructions Originale page 30

50275_Schlagschrauber_Expert_BA_171026.indd 30
Attention! For safety reasons, the torque is limited to 100
nm for clockwise direction. Please use a torque wrench to
tighten the wheel bolts to approximately 120 nm. Please
note that the wheel bolts must be retightened after a driving
distance of approximately 50 km. Inspect that the wheel bolts
are tight.
• For counterclockwise rotation (to remove mounting material), the
maximum torque is limited to approximately 300 nm. Ensure that the
rotational direction is correct prior to using the device.
• Release the on/off switch (3) to stop the tool. Disconnect the power
plug (2) from the power outlet after completing the work.
Practical tips:
• Removing/tightening bolts, screws, or nuts may require
several impacts.
• The longer you tighten a bolt, screw, or nut, the tighter it
will be. Avoid extended tightening to prevent damage to
the mounting material or the workpiece.
• Please also note that smaller mounting material frequently
do not need to be tightened as firmly.
• Oil, dirt, rust, and other substances possibly located on the
thread or under the screw head may influence the tightness
of the mounting materials.
Warning! Keep hands and power cord at a sufficient
distance from the sockets and all moving parts.
Warning! Let the motor come to a complete standstill
prior to switching between clockwise and counterclockwise
direction in order to prevent damage to the motor and other
parts.
30
26.10.17 14:01