steute RF UBR SW868-NET Instructions De Montage page 3

RF UBR SW868/SW915/SW917/SW922-NET AC/DC 4S/2S
//
Montage- und Anschlussanleitung / Funk-Aktor
Mounting and wiring instructions / Wireless actor
Instructions de montage et de câblage / Actionneur relais sans fil
Istruzioni di montaggio e collegamento / Attuatore wireless
Instruções de montagem e instalação / Atuador sem fio
Инструкция по монтажу и подключению / Радио-привод
English
Use of the mounting and wiring instructions
Target group: authorised and qualified staff.
All actions described in these instructions may only be performed by
qualified persons who have been trained and authorised by the
operating company.
1. Read and understand these mounting and wiring instructions.
2. Comply with the valid occupational safety and accident prevention
regulations.
3. Install and operate the device.
Selection and installation of devices and their integration in control
systems demand qualified knowledge of all the relevant laws, as well
as the normative requirements of the machine manufacturer. In case
of doubt, the German language version of these instructions shall
prevail.
Scope of delivery
1 device, 1 mounting and wiring instructions, carton.
Safety information
=
In this document, the warning triangle is used
together with a signal word to indicate a
hazardous situation.
The signal words have the following meanings:
NOTICE
indicates a situation which may
result in material damage.
WARNING
indicates a situation which may
result in serious injury or death.
Intended use
The four-channel wireless actuator is used to switch electrical loads
via radio transmission. The receiver must conform to the sWave.NET
protocol of the steute modules.
Mounting and wiring
The wireless range depends heavily on the local conditions. Conductive
materials may strongly affect the radio signal. This also includes thin
foils, e.g. aluminium laminations on insulation materials.
Antenna
The internal antenna of the device is located within the area of the
printed "nexy" logo. Maintain sufficient distance from sources
of interference.
CAUTION
indicates a situation which may
result in minor or moderate
injury.
DANGER
indicates a situation which will
result in serious injury or death.
Allocation of locations and radio frequencies:
Device type Radio frequency
SW868 868.3 MHz
SW915 915.0 MHz
SW917 917.0 MHz
SW922 916.5 MHz
Installation, mounting, dismantling
=
DANGER
Live parts. Electric shock hazard! Connecting and
disconnecting only by qualified and authorised per-
sonnel in zero-potential state .
=
DANGER
Live parts can lead to electric shock. Only connect
the device when it is de-energized. Disconnect the
device only when it is de-energized.
Mount the device on an even surface.
Application and operation
=
DANGER
Live parts. Electric shock hazard! Enclosure cover
must not be damaged. Enclosure cover must be
closed tightly. Pay attention to correct mounting
of enclosure cover. Observe tightening torque
of screws.
=
DANGER
Live parts. Electric shock hazard! Use cable glands
which are suitable for the degree of protection and
the used cable.
r
CAUTION
High temperatures. Risk of burns! For short-circuit
protection use appropriate fuse size. Observe per-
mitted ambient temperatures.
- Use device only within the permitted electrical load limits (see
technical data).
- Use device only within the permitted ambient temperature range
(see product label and technical data).
3 / 28
Place of use according to
EU 2014/53/EU (RED)
USA FCC
Canada IC
Mexico IFT
Brazil ANATEL
Japan ARIB STD-T108