Publicité
Les langues disponibles
Les langues disponibles
G
B
CLOSE COMMAND
Connect the CLOSE button between the clamps 3 and 12 of the
control board.
ATTENTION: leave it open if not used
ENCODER INPUT
Connect the SIGNAL cable of the encoder to the clamp 13 of
the control board.
Connect the GND cable of the encoder to the clamp 14 of the
control board.
Connect the cable +Vdc of the encoder to the clamp 15 of the
control board.
ATTENTION: leave it open if not used
PHOTOCELLS POWER SUPPLY
Connect the clamp 16 to the (+) clamp of the photocells
receiver.
Connect the clamp 17 to the (-) clamp of the photocells
receiver and transmitter.
Connect the clamp 18 to the (+) clamp of the photocells
transmitter.
ACCESSORIES OUTPUTS
Accessories output 24 Vac 3 W.
MOTOR OUTPUT
Connect the phases of the motor to the clamps 21, 22, 23, an
the ground to the clamps 24 or 25.
THE MOTOR SHOULD BE DELTA CONNECTED
For the connection of the motor we recom-mend to use a
screened cables 3 poles + earth 1.5 mm² (type FD781CY)
POWER SUPPLY
Connect the power supply cable to the clamps 26 and 27,
connect the ground to one of the clamps PE 28, 29 or 30.
COURTESY LIGHT
Connect the courtesy light to the clamps 33 and 34, 230 Vac
100 W MAX.
FLASHING LIGHT
Connect the flashing light to the clamps 31 and 32
38
The activation/deactivation of the encoder feature is controlled
in the MENU A
For the connection of the possible encoder we recommend to
use a screened cable 3 x 0,75mm2 (type OLFLEX-110CH)
Photocells test => Enabled through MENU A.
ATTENTION: the control board gives a voltage of 24 Vdc and can
supply a maximum power of 3 W.
Safety edges test => connect the test device of the safety edge
on the power supply pins of the TX (test activated with low logic
signal 0Vdc).
Please refer to the manual of the safety edge.
Before activating the automation make sure that all the safey
devices are correctly cabled and featureing.
Refer to the preliminary checkings section of chap.4
!! RISK OF ELECTRIC SHOCK !!
Do not connect the card directly to the electric network. Put a
device which can ensure the disconnection of each pole from the
power supply of the control board
Use a cable with correct section according to the current
absorbed by the motor.
It is possible to light up the action area of the automatism during
each motion.
The featureing of the auxiliary light is managed by the MENU A.
Use a flashing light without flashing card 230 Vac 60 W MAX
Publicité
