RIB SUPER 3000 FAST FCE Mode D'emploi page 36

G
B
1. INTRODUCTION
It can manage a 230/230 Vac 3-phase motor - delta
connected - max 1,5 KW (current limited to 10 A).
The inverter allows to adjust the forces and speeds of
the motor.
J-INV 3P is equipped with inputs for photocells and safety
edges, for SS (Step-by-step), PED (pedestrian opening),
OPEN (Open), CLOSE (Close), STOP commands, for limit
switches and with a large display with three buttons for
settings .
It is also equipped with connectors for a radio receiver, an
output for courtesy light and an output for flasher.
It is possible to connect an electric lock or an external
electric brake.
DO NOT INSTALL THE CONTROL BOARD
WITHOUT READING THE INSTRUCTIONS
FIRST!
230 Vac
50/60 Hz
ANTENNA
COM
SS
PHOTO
STOP
EDGE
L.S.CL.
L.S.OP.
PED
OPEN
CLOSE
ENCODER
SIG.
GND
PHOTO POWER SUPPLY
Antenna + RX
Common + TX
Step by Step W - V - U
Photocell PE
Stop N
Safety edge L
Closing limit switch SYSTEM MEMORY
Opening limit switch BLINKER
Pedestrian opening COURTESY LIGHT
Opening command ELECTRIC LOCK CARD CONNECTOR
Closing command RADIO RECEIVER
Encoder FUSE
Encoder signal INPUTS LED
Ground POWER ON LEDS
Photocells power supply
Photo Receiver
Photo transmitter
Motor connections
Ground
Neutral
Line
System memory
Flashing light
Courtesy light
Electrobrake card connector
Radio receiver
Fuse
Input leds
Power on leds
36