Boiler Guard - meibes BigFixLock Documentation Technique Mise En Service

6. Boiler guard

The boiler guard (see „boiler guard" technical information) can be connected directly to the distributor, or the angle connection depending
on the size and/or pumped quantity. For this, reduction couplings are offered. This way, the distribution system can be put together as
needed. Housing: welded round container with adapter props made from a seamless steel tube incl. a BigFixLock groove. In the base there
is an opening for cleaning is with a 1" drain valve. The 3/4 „sleeves in the ground are used to pick up magnetite separators, which are
sealed with plugs, if none are needed. An automatic floating vent, a rinsing ball cock and a pocket immersion sleeve for accommodating
the temperature sensor are located in the lid. The boiler guard is held in place by a foot. Supplied with EPP - block insulation.
Max. permissible pressure rating: PN 6 / Max. permissible temperaturer: 110 °C
*Note: The intermediate pipes of the foot are to be shortened to the required length to adjust the height of the manifold or boiler guard.
40
A Rinsing tap with a hose fitting (included)
B Settling chamber
C Immersion sleeve for the temperature sensor
D Flow straightener
F Perforated plates
G Dividers
H Sludge pot
I
Drain ball valve with a hose fitting (included)
J Magnetite separator
L Impact plate
M Automatic floating vent