Mac allister MPWP2200 Mode D'emploi page 35

MPWP2200 by MacAllister
Problem
4. Strong
pressure
fluctuations
5. Water
leakage
from
product
6. Excessive
vibration/
noise
7. No
detergent
taken in
8. No water
jet
MNL_MPWP2200_MAC_GB_V5_200528.indd 35
Possible cause
4.1. Nozzle clogged
4.2. Water inlet volume is too
low
4.3. High-pressure hose is
leaking
4.4. Seals worn
4.5. Intake filter dirty
4.6. Air being sucked into the
system
5.1. Seals worn
6.1. Screws and nuts
loosened
6.2. Motor problems
6.3. Water inlet volume is too
low
7.1. Soap tank not attached
7.2. Detergent too dense
7.3. Deposits or restriction in
detergent circuit
8.1 Trigger is not squeezed
8.2 Trigger lock is activated
8.3 No water supply
8.4 Filter is dirty
8.5 Hose blocked
8.6 Nozzle blocked
Troubleshooting
Solution
4.1. Clean the nozzle
4.2. Increase water inlet
quantity
4.3. Replace high-pressure
hose
4.4. Contact our nearest
authorised service centre
4.5. Clean the filter
4.6. Check thickness of hose
fittings
5.1. Contact your nearest
authorised service centre
6.1. Check screws and nuts
for tightness and re-
tighten as necessary
6.2. Contact your nearest
authorised service centre
6.3. Increase water inlet
quantity
7.1. Attach the soap tank
7.2. Dilute with water
7.3. Flush with clean water
and eliminate any
restrictions. If the problem
persists, contact an
authorised service centre
8.1 Squeeze the trigger
8.2 Deactivate the trigger lock
8.3 Check water supply
8.4 Clean filter
8.5 Check hose
8.6 Check nozzle
EN EN
35
5/28/20 8:39 AM