Mac allister MPWP2200 Mode D'emploi page 21

MPWP2200 by MacAllister
NOTE: The water inlet hose adaptor (22) contains a filter (22a) to
protect the product against larger particles. Ensure the filter is fixed
appropriately in position. Do not use the water inlet hose adaptor
without filter.
Connection to power supply
1. Make sure the on/off switch (16) is in its off position ("0").
2. Connect the plug with a suitable socket.
WARNING! Check the voltage! The voltage must comply with the
information on the rating label!
If using an extension cord it must be suitable for outdoor use with
sockets protected against water splashing. Ensure the extension
cord is of the proper size and type for your product (≥ 1.5 mm2)!
WARNING! The electric supply connection shall be made by a
qualified electrician and comply with IEC 60364-1. It is recommended
that the electric supply to this machine should include a residual
current device that will interrupt the supply if the leakage current to
earth exceeds 30 mA for 30 ms or a device that will prove the earth
circuit.
3. Your product is now ready to be used.
MNL_MPWP2200_MAC_GB_V5_200528.indd 21
Before you start
EN
21
5/28/20 8:39 AM