Mac allister MPWP2200 Mode D'emploi page 29

MPWP2200 by MacAllister
3. Maintain a further distance from the cleaning area when using jet spray.
4. Caution! Increase the distance from the cleaning area for softer woods.
Cement patios, stone, and brick (FULL POWER)
1. Rinse at high pressure using fan spray in a sweeping motion, keeping the
nozzle at least 7 - 15 cm from the cleaning surface.
2. Maintain a further distance from the cleaning area when using jet spray.
Cars, boats, and motorcycles (ECO MODE)
1. Clean one side at a time to achieve the best results.
2. Rinse at high pressure using fan spray in a sweeping motion, keeping the
nozzle at least 20 cm from the cleaning surface. Do not use narrow pencil jet
on vehicle or boat paint work.
3. Wipe surface dry for a polished finish.
4. Warning! Do not clean the engine with this product!
After use
1. Release the trigger (9d) (Fig. 22).
2. Turn the on/off switch to "0" position.
3. Turn off the water tap.
4. Squeeze the trigger to release the pressure still present in the product.
WARNING! Only separate the high-pressure hose from the spray
gun and the water hose from the product when no more pressure
exists in the system! Also ensure that the product is turned off and
separated from power supply!
5. Lock the trigger.
6. Separate the water hose from the water supply and then from the water inlet
hose adaptor (22).
7. Wind the pressure hose (3) onto the hose reel (2). Ensure that the hose is not
bent or twisted but winded up evenly.
MNL_MPWP2200_MAC_GB_V5_200528.indd 29
9d
0
Fig. 22
Operation
EN EN
29
5/28/20 8:39 AM