Mac allister MPWP2200 Mode D'emploi page 26

Product functions
EN EN
Rear wheel brake
Use the brake to lock the rear wheels and prevent unintended movement of the
product.
1. Step down the brake pedal (14) to lock the rear wheel. Slightly move the
wheel to ensure the brake lever is engaged properly. (Fig. 20).
NOTE: Always active both brakes at the same time during operation.
2. Lift up the brake pedal (14) to unlock the rear wheel.
Overload cut-out
In case it is overloaded, the motor stops. In this case, switch the product off,
remove the mains plug and let it cool down for 10 minutes, then repeat the start-
up procedure as described in below chapter-"operation".
If the problem recurs more than once, contact your authorised service centre.
Safety valve
The safety valve is a pressure limiting valve. When the trigger (8b) is released,
the valve opens and discharges the pressure inside the pump.
Automatic motor start-stop device
The automatic motor start-stop device is operated by the trigger (8b) of the spray
gun (8). When the trigger (8b) is released the dynamic pressure automatically
cuts out the motor. When the trigger (8b) is depressed the automatic drop in
pressure starts the motor and the pressure is restored after a very slight delay.
26
MNL_MPWP2200_MAC_GB_V5_200528.indd 26
14
Fig. 20
MPWP2200 by MacAllister
5/28/20 8:39 AM