Mac allister MPWP2200 Mode D'emploi page 30

Operation / Care and maintenance
EN EN
After use
8. Dismantle the accessories in the reverse sequence of the assembly
instructions if you are not going to use this product for a long period of time.
9. Check, clean and store the product as described below.
The golden rules for care
WARNING! Always squeeze the trigger to release the pressure still
present in the product first.
Always switch the product off, disconnect it from the power supply and
let the product cool down before performing inspection, maintenance
and cleaning work!
1. Keep the product clean. Remove debris from it after each use and before
storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
3. Inspect the product before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts.
WARNING! Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualified
specialist!
General cleaning
1. Clean the product with a slightly damp cloth and mild soap. Use a brush for
areas that are hard to reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
4. Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorised service centre before using the
product again.
30
MNL_MPWP2200_MAC_GB_V5_200528.indd 30
MPWP2200 by MacAllister
5/28/20 8:39 AM