Troubleshooting - Toshiba MMW-AP0271LQ-E Manuel D'installation

13

Troubleshooting

<RBC-AMT32E>
 Confirmation and check
When a trouble occurred in the hot water module, a
check code and indoor UNIT No. (including hot water
module) appear on the display part of the remote
controller.
The check code is only displayed during the operation.
If the display disappears, operate the hot water module
according to the following "Confirmation of trouble log"
for confirmation.
Check code Indoor UNIT No. (including hot
water module) in which a trouble
occurred
131-EN
 Confirmation of trouble log
When a trouble occurred on the hot water module, the
trouble log can be confirmed with the following
procedure. (The trouble log is stored in memory up to
4 trouble.)
The log can be confirmed from both operating status
and stop status.
2
3
1
1
When and buttons are pushed simultaneously
for 4 seconds or more, the following display appears.
If is displayed, the mode enters in the trouble log
mode.
• [01: Order of trouble log] is displayed in CODE No..
• [Check code] is displayed in CHECK.
• [Indoor unit address in which a trouble occurred] is
displayed in Unit No..
2
Every pushing of button used to set
temperature, the trouble log stored in memory is
displayed in order.
The numbers in CODE No. indicate CODE No. [01]
(latest) → [04] (oldest).
REQUIREMENT
Do not push button because all the trouble log of the
indoor unit (including hot water module) will be deleted.
3
After confirmation, push button to return to the
usual display.
<RBC-AMS55E-ES/EN>
 Confirmation and check
Check code
Code : P10 Unit : 2–2
45
Unit number of the
malfunctioning
indoor unit
Heat
Mode Fan Speed
Check
Check
Code:P10
Unit:2–2
Return
Contact Information
– 66 –
When an error has occurred in the air conditioner,
the check code and the unit number of the indoor
unit appear on the display of the remote controller.
* The check code appears only while the unit is
running.
Push the [ MONITOR] button or [
CANCEL] button to display the check information
screen.
While the check information screen appears:
Push the " Contact" [ F1] button to
Contact
display the contact number for service.
Push the " Information" [ F2] button
Information
to display the model name and serial number of
the unit.
132-EN