Publicité
Les langues disponibles
Les langues disponibles
Safety and Warnings
Installation and service
THE EQUIPMENT CONTAINS NO USER SERVICEABLE COMPONENTS.
Installation and maintenance of the equipment must only be carried out by trained and authorised
personnel.
Electrical installation
The mains lead must be connected to a supply outlet with a protective earth contact. The electrical supply
at the socket outlet must provide over current protection of an appropriate rating.
For your protection, all mains (110V or 230V) equipment used out of doors or in wet or damp conditions,
should be supplied from a correctly fused source and protected by an approved ground fault protection
device (RCD, GFCI etc.)
IF IN DOUBT SEEK ADVICE FROM A QUALIFIED ELECTRICIAN.
Pluggable equipment must be installed near an easily accessible socket outlet.
Routine maintenance
To avoid the possibility of electric shock or damage to the machine, always switch off the machine and
isolate from the power supply before carrying out any routine maintenance.
To avoid the risk of the machine falling, where applicable, ensure that it is placed securely on a flat and
level surface.
Cleaning the machine
The outside of standard products may be wiped down with a clean cloth, moistened with water containing
a small amount of mild detergent.
Harsh abrasives, solvents, scouring cleaners and alkaline cleaning solutions, such as washing soda,
should not be used, especially on the display windows. Under no circumstances should you attempt to
wipe the inside of the machine.
Do not spray any liquid directly onto the display windows. If you are using a proprietary cleaning fluid
ensure you spray the cloth and not the display.
Training
Do not attempt to carry out any procedure on a machine unless you have received the appropriate
training or read the Instruction Manual. To avoid the risk of RSI (repetitive Strain Injury) it is important to
ensure that the machine is placed on a surface which is ergonomically satisfactory to the user. It is
recommended that frequent breaks are taken during prolonged use.
Sharp Objects
Do not use sharp objects (screw drivers, long fingernails, etc.) to operate the keys.
EMC compliance
The following may be applicable to your machine.
WARNING: This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
Publicité
