Magmaweld RS 200 MK Mode D'emploi page 18

18 Installation
• If the CO2 heater is to be used, first connect the CO2 heater to the gas cylinder. After connecting the gas
regulator to the CO2 heater, insert the plug of the CO2 heater into the CO2 heater outlet on the back of the
machine.
EN
• If the CO2 heater will not be used, connect the gas regulator directly to the gas cylinder.
• Connect one end of the tube hose to the gas regulator and tighten the clamp. Connect the other end to the gas
inlet at the back of the machine and tighten the nut.
• Open the gas cylinder valve to check that the tube is full and that there are no leaks in the gas flow path. If you
hear a noise and/or detect a smell of gas as a leak indicator, examine your connections and eliminate leakage.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
RS 200 MK - RS 250 MK - RS 300 MK - RS 350 MK - RS 400 MK
www.magmaweld.com