JUMO eTRON M Notice De Mise En Service page 44

Parameter Meaning
Function of relay K2
No function: 0
Signal alarm message: 1 = relay is to pull in, 2 = relay is to drop out
Output timer message : 3 = relay is to pull in, 4 = relay is to drop out
Service interval elapsed: 5 = relay is to pull in / 6 = relay is to drop out
Alarms
Low alarm limit
If the process value falls below this limit during heating or cooling operation,
the alarm message
messages". If r 2= 1 or 2, relay K2 will also switch.
1
is output to the display, see Chapter 7 "Alarm
Value range
from...factory-set...to
0 ... 6
-999 ... -200 ... +999
16