GOK LAG 2000 A Instructions De Montage Et D'utilisation page 47

Figure 5: Electrical power connection of the display unit
Electrical potential!
Electric shock risk.
Switch off the power supply and make sure that it cannot be switched on again
inadvertently.
Connect the sensor unit
Connect – direct
Fig. 6: display unit can be connected directly Fig 7: display unit can be connected in directly
If the display unit
are installed beside each other, the sensor
cable can be connected directly with the
display unit
and the LDL tank
Leak detector type LAG 2000 A
A1
Light "Operation"
A2
Button "Alarm sound"
A3
Light "Alarm"
A4 Alarm buzzer
Button Test
A5
A6 Nipple for cable lead-through
A Terminal for "power supply"
B Terminal for additional "alarm"
C Terminal for sensor cable
Via terminal "Power"
AC voltage 230V/ 50Hz.
Use only a fixed connection, not a pug
or switch.
Insert the cable through the nipple.
Connect the cable according to the
terminal block designation.
Connect – indirect
If the display unit
in different rooms or more than 0.4 m apart,
the sensor cable
„A".
and the LDL tank
must be extended.
are
19 / 28