LGB Ge 6/6 I 412 Serie Mode D'emploi page 7

Operating Mode Selector (in the engineer's cab, Figure 1)
Upper Switch
Pos. O Current supplied from the catenary
Pos. U Current supplied from the track
3-Step Operating Mode Selector
Pos. 0 Locomotive standing on the track with no current
Pos. 1 Lighting turned on
Pos. 2 Motors and lighting turned on (normal operation)
Multi-Purpose Socket (Figure 2)
There is a multi-purpose socket for flat plugs on the front
and the rear of the locomotive. When you equip a car with
interior lighting or with a sound module, you can connect
these circuits to this socket and provide track power to
them. Each of the sockets is provided with a protective
sleeve.
Lubrication
Oil the ends of the side rods now and then with a drop of
LGB maintenance oil (item no. 50019).
Changing Light Bulbs (interior lighting)
The locomotive body must be removed in order to change
the light bulbs.
- Remove the 6 screws on the roof.
- Remove the roof.
- Change the plug-in light bulbs.
- Make sure of the wire connections when putting the
locomotive back together.
Changing Light Bulbs (headlights)
- Remove the upper lanterns and change the light bulbs.
- Unscrew the lower lanterns from below.
- Remove the lanterns and change the light bulbs.
Changing Traction Tires
- Using a screwdriver, carefully lift the old traction tire
from the groove in the wheel.
- Mount the new traction tire and press it into the groove.
Spare Parts
63120 Current pickup carbon brushes with sleeves, 8 pieces
63218 Pickup shoe contacts, 2 pieces
63403 Double arm pantograph
68511 Clear plug-in light bulb, 5 volts, 10 pieces
69104 Traction tires 37.5 mm / 1-15/32", 10 pieces
7