Stealth Cam STC-GX45NGW Manuel D'instructions page 14

CAMERA SETUP (cont.)
!
Time Lapse: Camera takes a still image per preset time.
o
Time Lapse Settings are: Photo Resolution, PIR Delay, Time Lapse Delay, Time Lapse
Start, Time Lapse Stop, Blur Reduction, Camera Name, Temperature, Information Bar,
Latitude, Longitude, Factory Reset, Security Key, Format SD Card, Software Upgrade.
o
Time Lapse Photos will be marked with "TL" in the Information Bar.
o
The Time Lapse Start setting determines when the Time Lapse session will begin.
o
The Time Lapse Stop setting determines when the Time Lapse session ends.
o
The Time Lapse Delay determines the time frequency between each photo in Time
Lapse mode.
o
When the Time Lapse Delay is set to 59 seconds or less, the PIR sensor will not be
active between Time Lapse photos.
o
When the Time Lapse Delay is set to 60 seconds or greater, the PIR sensor will be
active between the Time Lapse session.
o
The camera will not be able to take photos outside of a Time Lapse session.
!
PIR Video: Camera takes a Video per PIR trigger.
o
PIR Video Camera Settings are: PIR Delay, Video Resolution, Video Length, Video
Audio, Activity Control, Camera Name, Temperature, Information Bar, Latitude,
Longitude, Factory Reset, Security Key, Format SD Card, Language, Software Upgrade.
o
10 to 180 seconds adjustable video per PIR trigger.
o
The maximum video length for a nighttime IR video is 30 sec.
o
The full information bar must appear at the bottom of the video if the information bar
setting is turned ON.
o
Videos will be named as STC_XXXX.avi in the DCIM/100STLTH folder, where XXXX is the
current photo/video count.
www.stealthcam.com
877-­‐269-­‐8490
Page
14