The Digital Control Board system is an intricate and valuable piece of technology. For protection from power surges and electrical
shorts, consult the wire diagram below to ensure your power source is sufficient for the operation of the unit.
PB – ELECTRIC REQUIREMENTS
110-120V, 60HZ, 220W, 3-PRONG GROUNDED PLUG
NOTE: Electrical components, passed by product safety testing and certification services, comply
with a testing tolerance of ± 5-10 percent.
FUEL INPUT ATING:
0.5 KG/H (1.1 LB/H)
INDEX
W : WHITE
Y : YELLOW
DRAFT FAN
P : PURPLE
120V, 50/60HZ,
R : RED
0.1 AMP, 1 PHASE
K : BLACK
S : SILVER
G : GREEN
22
ELECTRICAL WIRE DIAGRAM
LOCATE AND REMOVE
THE SIX SCREWS
OF ACCESS PANEL ON
LEFT SIDE OF UNIT
DIGITAL CONTROL BOARD
Y
P
Y
Y
G
R
W
G G
R R
Y Y
AUGER MOTOR
& FEED SYSTEM
120V, 50/60HZ, 0.22 AMP,
2 RPM MOTOR
GRILL PROBE
SPADE CONNECTORS
FAST-BLOW FUSE
5 AMP
GRILL PROBE
S
K
K
W
W
G
W
P
P
W
IGNITER ASSEMBLY /
HD CARTRIDGE HEATER
WW
200W, 120V, 2.6 AMP
0.375" X 5.000"
W
W
IGNITER
GROUNDED
POWER CORD
VW-1, 105°C/221°F,
18-3 STANDARD
GROUND
BURN POT