Kreg Crown-Pro NK7825 Guide D'utilisation page 5

Assembly
G
F
A
Slide Guide
I
H
Fig. 1
A
H
B
I
Fig. 2 Fig. 3
Step 2.
Add the 10 included Rubber Feet (B) to the Base (A)
for a solid hold on your work surface (Fig. 3). Connect
the Molding Platform (F) to the Base (A) with the Large
Bolt (G) (Fig. 1). Place the Slide Glide (I) over the
bolt (as shown) and secure it in place with the Plastic
Thumb Nut (H) (Fig. 2).
Step 3.
J
Use the two Small Screws (J)
to secure the Spring Scale
J
(K) to the Base (A). Do NOT
over tighten, the screws will
K
fully set after one and a half
turns of a screwdriver.
www.kregtool.com