Kreg Crown-Pro NK7825 Guide D'utilisation page 11

Position your molding on the Crown-Pro
6
and make your cut.
Once the Crown-Pro
been correctly set, it's time to make your first cut.
Before you set the molding in the Crown-Pro
you must first flip it 180°. This will make it so your
molding is upside down (as shown). The bottom of your
molding will actually be face-up in the Crown-Pro
Place the inverted molding onto the Crown-Pro
hold it in place with your hand, and make your cut
as desired.
Step-by-Step
and the miter saw have
™
Bottom of Molding
(against the wall)
Top of Molding
(against the ceiling)
™
www.kregtool.com
™
.
™
,
™