Pentair SHURFLO 94-009 Serie Notice De Montage

SHURFLO
FAUCET FIXTURES 94-009-XX
®
INSTALLATION INSTRUCTIONS

CAUTION: Faucet with switch is not to be used in a flamable environment. Not to be used with AC voltage. Faucet must be
mounted in accordance to all applicable codes.
Please refer to installation drawings when following instructions.
FEATURES & SPECIFICATIONS
❚ Liquid Temperatures to 176° F
❚ Pressures to 87 psi
❚ Integral Switch Rated at 3 amps @ 12VDC
❚ Faucet Rotates for a variety of tasks
❚ Model 100 Pump Max. Temp. 120°F
❚ Model 100 Pump Max. Pressure 12PSI
❚ c-UL Listed
WATER PURFICATION
TIPS
SYMPTOM: Switch clicks, but pump
does not turn on
LOOK FOR: Power turned off, blown
fuse, low battery, bad wiring, bad switch
Check Voltage at Pump and Switch
SYMPTOM: Pump runs, but no water
comes out
LOOK FOR: Empty water tank, kinked or
clogged inlet hoses, inlet hose not tight
or out of water, pump burnt out Pour
Water into Inlet of the pump, Check
Hoses
911-451 REV. N
FOR INSTALLATION WITH A
MODEL 100 PUMP
(pump with no pressure switch)
1. Measure and drill a 3/4" hole in
countertop. (For Dual Hot/Cold faucet
drill a 1-3/8" hole)
2. Slide black gasket, then the spacer
over wires and onto unit. Test mount
unit in hole.
3. Check to see if enough threads show
to attach nut. If not enough threads
show, remove the spacer.
4. Slide nut over wires and tighten on
threads. A thread locking solution may
be used to keep nut tight.
5. Attach one faucet switch wire to the
positive wire of the pump.
6. Attach the other wire to the positive
side of the 12 VDC source.
7. A fuse rated for the pump should be
installed in the line.
8. Attach negative wire of pump to
ground or negative terminal.
9. Install 3/8" inner dia. tubing from
pump outlet to faucet inlet. Use proper
sized tubing clamp. Model 100 pump
must have flooded inlet from tank.
FOR INSTALLATION WITH A
SHURFLO DEMAND PUMP
Follow instructions above for mounting
the fixture, noting the following:
Faucet unit may not have wires. Do Not
Attach Faucet Switch Wires.
For pump installation refer to pump
installation instructions.
1