Publicité
Les langues disponibles
Les langues disponibles
10-801 / 10-802
Step 4: ending programming status
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1 1
1
3 3
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
Briefly press
the "mode" button
NOTE: The parallel programming of multiple internal units (max. 2 on the power supply
module or more with the service unit) will increase the power consumption. The
numbers given in table 1 will then NO LONGER apply.
Remark: If you do not have access to the premises, and thus cannot pick up the receiver of
the internal unit, you can carry out the programming via the service unit (reference:
10-870, see manual). If a bell push-button is present at the front door, you can
also carry out the programming as follows:
Step 1: entering system programming status
The LED is on.
14 15 16 17 18 19 20 21 22 23 24 25
1
2
3
4
5
6
7
8
9 10 11 12
Briefly press
the "prog" button
Step 2: linking the bell push-button to the correct internal unit
12V 1A max
12V 1A max
12V 1A max
Step 3: programming a bell push-button
Briefly press the relevant bell push-button at the front door. You hear a
ringing signal both on the internal and external unit in confirmation of
the programming.
26
13
Press the bell push-button at the door, release it and press it
again (within 3s
1
2
6s
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1
1 1
3 3
1 2 3 4 5 6 7 8 9
The LED lightens steadily.
14 15 16 17 18 19 20 21 22 23 24 25
13
1
2
3
4
5
6
7
8
9 10 11 12
The LED blinks.
10 11 12 13 14 15 16 17
EN
Publicité
