Publicité
Les langues disponibles
Les langues disponibles
10-801 / 10-802
In order to activate or deactivate this mode on the power supply, proceed as follows:
14 15 16 17 18 19 20 21 22 23 24 25
ACTIVATING:
Press the Prog. key until the LED
1
2
3
4
5
6
7
8
9 10 11 12
13
blinks (±3s).
14 15 16 17 18 19 20 21 22 23 24 25
DEACTIVATING:
1
2
3
4
5
6
7
8
9 10 11 12
13
Briefly press the Prog. key.
Also with the video internal units, this special mode is used in order to allow the function
key, which normally is used to switch the light, to be used to set up a second internal call.
Remark: When the power supply module used is put in this mode, the entire system will
be in this mode. It is not possible to activate this functionality for 1 telephone.
Programming or reprogramming the system
You can programme the push-buttons and internal units to link each push-button to 1 or 2
internal units (see parallel programming, step 2). If you want to connect more internal units
in parallel, you will need the service unit (10-870). Conversely, you can assign 1 internal
unit to 1 or more push-buttons. Programming and resetting a push-button (step 2) and
parallel programming (step 3) are described below.
Step 1: entering system programming status
The LED lightens.
14 15 16 17 18 19 20 21 22 23 24 25
Briefly press
the "prog" button
1
2
3
4
5
6
7
8
9 10 11 12
24
14 15 16 17 18 19 20 21 22 23 24 25
➧
Let go of the Prog. key.
1
2
3
4
5
6
7
8
14 15 16 17 18 19 20 21 22 23 24 25
➧
The LED on the power supply
1
2
3
4
5
6
7
8
13
Briefly press the Prog. key in confir-
mation. The LED on the power supply
9 10 11 12
13
9 10 11 12
13
blinks.
14 15 16 17 18 19 20 21 22 23 24 25
The LED blinks.
1
2
3
4
14 15 16 17 18 19 20 21 22 23 24 25
➧
1
2
3
4
5
6
7
8
9 10 11 12
continuously lights.
14 15 16 17 18 19 20 21 22 23 24 25
➧
Press the Prog. key until the LED
1
2
3
4
5
6
7
8
9 10 11 12
again blinks continuously (±3s).
5
6
7
8
9 10 11 12
13
13
13
EN
Publicité
