Niko 10-801 Mode D'emploi page 25

10-801 / 10-802
Step 2: programming a push-button
(With a new programming. Overwriting is not possible. See 'Resetting a push-button').
Pick up the receiver
You hear the ringing signal both on the internal and external unit.
Or:
resetting a push-button (in case you want to reprogramme a push-button).
Keep pressing until you hear 2 beeps (about 6s.).
Step 3: programming 2 internal units in parallel
(The system assumes that 1 internal unit has already been programmed on the relevant
push-button, see step 2)
Pick up receiver
of unit 2
You hear the ringing signal both on the internal and external unit.
EN
Press the bell push-button.
1 2
6s
Press the same push-button
until you hear 3 beeps.
Put the receiver down
Put receiver down again
25