Niko 10-801 Mode D'emploi page 23

10-801 / 10-802
Connecting a light circuit
A light circuit can be connected to the potential free contact (24V and 1A) of the power
supply modules. Connect the light circuit to terminals 14 and 18 (jumpering 15 and 16)
of POWER SUPPLY 20, see fig.3. An additional transformer is needed to power the circuit
(depending on the connected load/resistance).
8 - 10 Vac
230 Vac
10 A
Fig.3: connecting a light circuit (230V~) to POWER SUPPLY 20
Modifying the activation time of the lighting
Turn the potentiometer to the desired value. This value always lies between 0,5s. and 5 min.
Press the programming key on the power supply module. The LED on the power supply
module blinks. Then again press the programming key. The LED lightens steadily. The time
has been set.
Operating the light circuit from the internal units
Any non-programmed push-button on the external unit switches the light relay contact of
the power supply. Most internal units (audio and video) are equipped with a push-button
for switching the light relay contact. The 10-501 however only has 1 push-button. To use
this push-button in order to open the lock AND to switch the light, you must put the power
supply module in a special mode.
Operation of the door open key:
- receiver put down: light switch relay switches if the door open key is pressed!
- receiver picked up: door open relay switches if the door open key is pressed!
EN 23