Pressure Regulator Location
Remove rear cover to expose pressure regulator.
Regulator Cover
Oven Shutoff Valve
Gas valve to oven is turned on at factory, but could
accidently be turned off during installation. Verify valve is
turned on.
H
R
G
A A
Off
Check Oven Shutoof Valve
H
R
G
A A
On
Converting for Use with Natural Gas or
Propane Gas
This range arrives from factory adjusted for use with
natural gas. If using LP/propane gas is desired, range
must be converted. See "Type 1" or "Type 2" regulator.
!
To avoid electric shock that can cause personal injury
or death, disconnect main electrical supply to range
before servicing.
Converting Type 1 Pressure Regulator for Use with
LP/ Propane
1. Remove pressure regulator cap with a wrench.
2. Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic
insert firmly into hole in pressure regulator cap.
• Cap must show "LPG10" or "LP10".
A
A—Cap
B—Plastic Insert (LP setting)
C—Spring Location
Type 1 Pressure Regulator
4. Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of regulator.
8
WARNING
B
C