CLAS DM 1000 Mode D'emploi page 19

DM 1000
AUTOMATIC TYRE CHANGER 10"-24"
Mounting the tyre
Note: Make sure that the size of the rim and the tire is the same before mounting.
Clamp the rim on the turntable
Grease both side of the tyre and rim.
Place the demount head (4) on the edge of the rim, and move the air valve aim at the
mount/demount head.(Fig. 17)
Place one side of the tyre on the upside of the tail of the mount/demount head (4), then
press the other side of the tyre under the mount/demount head (4), to make the tyre enter
the groove of the rim. (Fig. 18) Pressing the pedal (8) to turn the turntable clockwise, and
complete mount the bottom part of the tyre on the rim.
Repeat the above steps to mount the upper bead.
Note: It is not necessary to rotate the locking handle or loose the vertical arm every time,
if the size of the rims is the same, just step the pedal to tilt backward the post (avoiding
the aging of the locking valve).
Do not put your hand between the tyre and clamps and never stand behind the machine, avoiding body injury.
Never adjust the pressure control valve inside the machine, otherwise the locking valve might be damaged.
19