CLAS DM 1000 Mode D'emploi page 14

DM 1000
AUTOMATIC TYRE CHANGER 10"-24"
TECHNICAL DATAS
Operating pressure: 8~10bar
Electric motor: 1.1kw/0.75kw
Power supply: 230V/400V
Working temperature: 0°~45°C
Max.wheel width: 400mm
Max.wheel diameter: 1040mm
Outside locking(RIM): 10''~20''
Inside locking(RIM): 12''~23''
RPM of turntable: 6rpm/min
Noise level: <70dB
INSTALLATION & TESTING
Installation place
Choose the installation site according to the rules on safety at work. Moreover, the installation space must allow the
operator to use the machine and all its components without any restriction. In case of the installation is in the open
area, it is necessary to protect the machine by means of a protective shed. Never use the machine in the place
with ammable gas, and never place the machine in the extreme temperature or humidity environment, the surface
of the machine should against lots of dust, ammonia and diluent etc.
Unpacking
After unpack the package, checking the eyeable damage on the machine and the component due to the shipment,
if there is some problems please contact with the dealer. The packing material such as plastic, nail, screw, wood
and carton should be put into the waste box or be handled according to the local regulations.
Note: The operator should wear the gloves, so as to avoid the injury when unpack the machine.
Power and air connection
Any electrical connection should be done by the specialized technician. Check if the power and air sources are in
accordance with the speci cation on the nameplate before operation. The electrical net, with which the machine
connected should have a stabilizer to protect the machine.
If the voltage is not stable r, a voltage stabilize should be connected between the power source and the machine.
The machine should be well earthed .An automatic air-switch should be adopted with the main power supply.
The power voltage only would change +10%.
Note: If there is no power plug on the machine, the user should mount on one, which suitable for the electric current
over 16A or connect the power supply directly according to the above demand.
For the machine with the motor of 3PH, step the pedal (8) after the connection of the power supply and the turntable
(V) should turn in a clockwise direction. If the turntable turn in the counterclockwise position, reverse any two of the
wires in the three-phase plug, the damage caused by the ignorance of the above instruction, will not be covered
by the manufacturer.
14