StarLab N2400-8030 Mode D'emploi page 8

Transmission method: Asynchronous signal transmission.
x
Mode of transmission: Fully Duplex.
x
1 start bit; 8 character bits; 1 stop bit.
x
Transmission speed: 9600 bit/s.
x
6. Maintenance and cleaning
Proper maintenance and cleaning will keep the instrument in good working order and will
x
lengthen its life time.
Be careful not spray cleaning fluid into the instrument. Unplug the power cord when cleaning.
x
Please use only Isopropyl alcohol and water containing tenside. Before using other methods
x
or cleaning agents the user must ascertain with the manufacturer that this will not destroy the
instrument.
Wear protective gloves during cleaning of the instrument.
x
When not in use for long periods, switch off the instrument and store it in a dry, clean and stable
x
place at room temperature.
Warranty
This instrument is under warranty to be free from defects in materials and workmanship under nor-
mal use and service, for a period of 24 months from the date of invoice. The warranty claim expires if
the instrument is opened by untrained or unqualified staff. Our "General terms and conditions" apply.
Service
When help needed, please contact Starlab or your Starlab distributor.
See www.starlabgroup.com for your local contact.
Please provide the customer care representative with the following information:
Serial Number (on the rear panel)
x
Description of problem (i.e., hardware or software)
x
Methods and procedures adopted to resolve the problems
x
Your contact information
x
7