Switching Modes; Supported Load - StarLab N2400-8030 Mode D'emploi

The left LCD panel displays "SAFE" and the right LCD panel displays the upper speed limit
x
(---rpm) which cannot be changed.
The LCD displays run modes "StA" for about 2 seconds.
x
The set speed value is shown in the left display, and the set time value is shown in the right
x
display. Then set the motor rotary speed and time.
After pressing the speed knob or time knob, the instrument begins to run at the set speed.
x
The actual speed and time remaining are shown in the LCD. If the time has reached zero,
the shaker stops its motion.

Switching modes

Switch the operating mode as follows:
Turn OFF the instrument with the main switch.
x
Hold down both the speed control and the time knob together and turn ON the instrument at the
x
mains switch. After about 5 seconds, you can let go of the knobs.
Switch between operating Modes A and B in order.
x

Supported load

In order to ensure safe operation, the shaker must only be operated with a
x
maximum load of 7.5 kg.
Make sure the shaking platform is always clean and level. The individual shaking vessels must
x
be placed evenly and fastened securely in the middle of the shaking platform whether either
single or multiple vessels are being used.
Troubleshooting
Instrument does not work when switched ON:
x
- check the power cable is fitted securely and the power is switched on.
- check that the fuse is not faulty.
The speed cannot reach set value:
x
- check that the platform is not overloaded.
The motor does not start by pressing the speed knob and time knob:
x
- check that the time is not set to zero.
Interface
The motor does not start by pressing the speed knob and time knob:
x
The shaker can be equipped with a special adapter and cable which can be used to link it
to an external device (Standard 9-pin interface to connect with the PC).
The cable between the shaker and the computer uses EIA Standard RS232C communicatio
x
line, corresponding to the DIN 66020 interface.
6