Windsor Treadway Instructions page 14

Replacing the roller brushes and the in-
take brushes
Loosen all the four screws and remove
the bearing lid.
Remove the roller brushes (large) and in-
take brushes (small) and replace them
(pay attention to the hexagonal intake of
the brushes!).
Also check simultaneously the combs
and the guide rails and replace or clean
them as required.
14
English
Replacing the combs
Remove the combs and replace them.
To do this, slide the inlet combs on the
narrow rails and the outlet combs on the
wider rails.
Cleaning the suction nozzles
Pull out all dirt particles from the suction
nozzles; do not push them in.
Replacing the guide rails
Loosen the fastening screws of the hol-
der for the guide rails.
Dismantle the guide rails.
Insert the guide rails in reverse se-
quence. Ensure that they sit properly.