Cequent Performance Products TOUGH & TRUSTED BULLDOG DCH Serie Manuel D'instructions page 14

1.6.3 wireless Remote and Transmitter Operation
1. Install Battery
a. Remove the three screws from the wireless
transmitter.
b. Separate the top section, insert the battery
positive (+) side up and replace the top sec-
tion.
c. Replace the three screws.
2. Start
a. Press the Power Button for 5 seconds until the Green light comes on.
b. Press the In/Down or Out/Up button. The Red indicator light will come on.
Power Button
Cable IN
3. Stop
a. The system will automatically shut down the transmitter if not activated for 5 minutes.
b. Press and hold the Power Button for 5 seconds to shut down the transmitter.
4. Reset
a. Press and hold the Programming Button for 5 seconds until the Red indicator illuminates.
b. Press the Power Button on the transmitter for 5 seconds until the Green indicator lights up.
c. P ress the In/Down or Out/Up button on the transmitter until the Red indicator light on
the receiver turns off.
d. Reset is now completed. Please note only one remote transmitter can be reset for each receiver.
5. Notes
a. Press and hold the Programming Button for 5 seconds until the Red indicator illuminates.
b. Press the Power Button on the transmitter for 5 seconds until the Green indicator lights up.
c. P ress the In/Down or Out/Up button on the transmitter until the Red indicator light on
the receiver turns off.
d. Reset is now completed. Please note only one remote transmitter can be reset for each receiver.
14
CEQUENT
Installation Instructions
Figure 15 - Operations
LED Indicator
Cable OUT
Figure 16 - Resting
PERFORMANCE PRODUCTS, INC. •
™
Figure 14 - Battery Replacement
Cable IN
LED
Programming
Indicator
Button
F3839-00 REV C (4782) 08/15
Lithium Battery:
CR2032 (3V)
Cable OUT